1.

論文

論文
小保方, 富夫 ; 橋本, 徹 ; 五十木, 慎一 ; 柄沢, 隆夫 ; 志賀, 聖一 ; 倉林, 俊雄
出版情報: 日本機械学會論文集. B編.  58  pp.2036-2040,  1992-06-25.  日本機械学会
概要: application/pdf<br />Journal Article<br />The swirl and axial components of gas velocity in the disk-type combustion cha mber of a firing engine were measured by an LDA. The engine was operated under the conditions of a speed of 1500rpm, η_υ=0.5, φ=1.4 and ignition timing of 30°BTDC. The gas velocities at 9 points on a diameter at midheight of the combustion chamber were analyzed by the cycle-resolved method. The bulk (mean) velocity was determined by the frequency discrimination method with the cut-off frequency of 667Hz. The flame propagation pattern was detected by ionization probes set at 17 points on the piston. It has been observed that, in the case of fired operation, the turbulence intensity is higher, the integral length and micro length scales are longer and the swirl flow is weaker and is eccentrically shifted compared with the case of motored operation. These results show that it should be noted that there are remarkable differences in the gas flow between motored operation and fired opeation. 続きを見る
2.

論文

論文
高橋, 秀夫 ; 志賀, 聖一 ; 小柴, 英俊 ; 柄沢, 隆夫 ; 倉林, 俊雄
出版情報: 日本機械学會論文集. B編.  56  pp.1837-1842,  1990-06-25.  日本機械学会
概要: application/pdf<br />Journal Article<br />The purpose of this study is to clarify the characteristics of diesel spray with higher and unsteady injection pressure under an elevated pressure condition and an elevated pressure and temperature condition. A Bosch-type injection system and a rapid compression machine were used. The behavior of the spray until 2 ms after the beginning of injection, which corresponds to the period of the ignition delay of most diesel engines, was observed by high-speed photography. Under the less evaporating condition, the spray penetrations of higher and normal injection pressure are almost the same, whereas, under the evaporating condition, those penetrations are not the same. Thus, the penetration of the normal injection pressure is affected by the ambient temperature, while the penetration of the higher injection pressure is little affected by the evaporation. The same tendency was observed in the behavior of spray cone angle development. It is also shown that the spray generates small eddies and the spray pattern is affected by the growth and dissipation of those eddies. 続きを見る
3.

論文

論文
高橋, 秀夫 ; 志賀, 聖一 ; 柄沢, 隆夫 ; 倉林, 俊雄
出版情報: 日本機械学會論文集. B編.  56  pp.1218-1221,  1990-04-25.  日本機械学会
概要: application/pdf<br />Journal Article<br />A rapid-compression machine is developed for fundamental studies of diesel combustion. Low-pressure compressed air and a stainless-steel membrane are employed to drive the piston. This is similar to the principle of a shock tube and is quite simple compared with other machines. The combustion chamber has a 120 mm bore and is 20 mm in depth. These dimensions were determined to avoid the impingement of the spray within 2ms, which seems to be a typical ignition delay period. Compression time and polytropic exponent are about 38ms and 1.30, respectively. High-speed photographs were taken to observe the spray development for both evaporating and non evaporating spray, and the effect of evaporation could be shown clearly. A combustion test was also carried out, and a pressure rise due to combustion was recognized. Thus, it is shown that this machine has sufficient performance for the study of diesel combustion. A simple simulation technique to design the machine is also presented and its availability is verified. 続きを見る
4.

論文

論文
柄沢, 隆夫 ; 川口, 暁生 ; 志賀, 聖一 ; 倉林, 俊雄
出版情報: 日本機械学會論文集. B編.  54  pp.1848-1855,  1988-07-25.  日本機械学会
概要: application/pdf<br />Journal Article<br />This paper presents an experimental study being aimed at revealing the ignition assistance effect of a hot surface in an alcohol-fueled diesel engine and its mechanism. A single shot of spray was injected into a motored diesel engine. Ignition lag was measured and was split into two regimes, physical lag and chemical lag, by applying a statistical technique presented by S. Kumagai. High-speed direct photographs were also taken. The dependence of those ignition lags were classified into three regions on their Arrhenius plots. In lower hot-surface temperatures, the ignition lags decrease exponentially with increasing the hot-surface temperature. In higher temperature regions, the ignition lags tend to have constant values, passing through the transient region. By combining the high-speed photographs, it is suggested that the hot surface does not initiate flame propagation, but supplies heat to assist the spontaneous ignition as the assistance mechanism. 続きを見る
5.

論文

論文
志賀, 聖一 ; 柄沢, 隆夫 ; 倉林, 俊雄
出版情報: 日本機械学會論文集. B編.  53  pp.1443-1451,  1987-04-25.  日本機械学会
概要: application/pdf<br />Journal Article<br />To predict the shape of a flame in a vessel is one of very important problems in the field of combustion. But it is difficult because the shape is strongly influenced by the flow which is affected not only by the surrounding walls but also by the expansion of gas due to combustion. The mechanism of formation of a wedge shaped flame in a constant volume combustion chamber has longtime been a target of many researchers since Ellis pointed it out in 1928. Several hypotheses have been proposed but they do not clearly present a complete mechanism. Modern techniques of measurement are giving new data about the combustion gases. In this report, a two dimensional LDV and some other measuring techniques are used to check the hypotheses mentioned above, and a new idea on the mechanism of formation of a wedge shaped flame is proposed. 続きを見る
6.

論文

論文
志賀, 聖一 ; 江原, 秀治 ; 柄沢, 隆夫 ; 倉林, 俊雄
出版情報: 日本機械学會論文集. B編.  51  pp.3817-3822,  1985-11-25.  日本機械学会
概要: application/pdf<br />Journal Article<br />This paper presents one of the studies which aim to reveal the capability of controlling diesel combustion by exhaust gas recirculation (EGR). In a previous paper, the effect of EGR on soot emission was examined, and it was shown that soot emission is suppressed under the condition that the mass fraction burned by spontaneous (pre-mixed) combustion is increased. In a present paper, diesel knock intensity is defined as a sound pressure distributed over 1-1.5kHz, and the effect of EGR on the diesel knock intensity is examined. The diesel knock intensity is remarkably reduced by EGR under the same operating condition as soot emission is reduced by EGR. By calculating the heat release rate based on the indicated pressure diagram, it was suggested that a reduction of knock intensity originates from the reduced reaction rate in the spontaneous ignition. The quantitative relationship between the diesel knock intensity and the maximum rate of pressure rise is also presented. 続きを見る
7.

論文

論文
志賀, 聖一 ; 江原, 秀治 ; 柄沢, 隆夫 ; 倉林, 俊雄
出版情報: 日本機械学會論文集. B編.  51  pp.3823-3827,  1985-11-25.  日本機械学会
概要: application/pdf<br />Journal Article<br />In previous paper, it was suggested the effect of exhaust gas recirculation (EGR) on the diesel knock is relevant to the reaction rate of spontaneous ignition which occurs at the initial stage of diesel combustion. In a present study, this suggestion is verified by measuring the ignition lag and separating it into physical and chemical lags by applying the statistical technique presented by S. Kumagai. Under the operating condition used in this study, the physical lag is rather longer than the chemical lag and hardly changes with an increase in EGR ratio. On the other hand, the chemical lag is considerably affected by EGR. Though the dependent behaviour of the chemical lag on EGR is not simple, it is clearly shown that the tendency of chemical lag versus EGR ratio is quite the reverse of that of the diesel knock intensity. This means that the diesel knock intensity with EGR is dominated by the reaction rate of spontaneous ignition. 続きを見る
8.

論文

論文
志賀, 聖一 ; 江原, 秀治 ; 柄沢, 隆夫 ; 倉林, 俊雄
出版情報: 日本機械学會論文集. B編.  51  pp.1105-1112,  1985-05-25.  日本機械学会
概要: application/pdf<br />Journal Article<br />By using a direct injection diesel engine, the effect of exhaust gas recirculation (EGR) on soot emission was investigated. It was revealed that EGR had both effects of soot promotion and suppression. Soot emission was suppressed when the premixed (initial rapid) combustion fraction of the two combustion patterns was increased, which was accomplished by throttling the intake valve equipped the engine or advancing the injection timing. It was also suggested that the effect of EGR on soot emission should not ascribe only the physical or thermal properties of the inert gases within the exhaust gas, but some chemical properties of CO_2. Because it was shown that only CO_2 had the effect of soot suppression under some conditions. 続きを見る